Schwinn IC2 Service Manual page 26

3. Loosen and pull the Adjustment Knob (A) that holds the
Handlebar Post in position in the Main Frame.
Hold the Handlebar so that it does not fall.
4. Remove the Handlebar assembly from the Main Frame.
NOTICE: Do not crimp the cable.
5. Loosen and remove the hardware that attaches the Handlebar
to the Handlebar Post. Set the hardware safely aside for
reassembly.
6. Discard the old part.
7. Installation is the reverse procedure.
NOTICE: Make sure that the Adjustment Knob engages the
holes in the Handlebar Post.
8. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
A
26