Schwinn IC2 Service Manual page 54

4. Loosen the Resistance Knob (R) to the minimum resistance
setting.
5. Using a 3mm hex key, remove the hardware (1a) that attaches the
Brake Assembly (1) to the Frame Mount (2). Set the hardware safely
aside for reassembly.
Note: The nuts may turn along with the screws when you try to
loosen the hardware (1a). To hold the nut stable, wedge
a small flathead screwdriver diagonally between the nut
and the inside of the Frame Mount bracket (2).
6. Remove the Brake Assembly (1) and set it safely aside.
7. Carefully remove the Chain Guard Door (3),
and set it safely aside for reassembly.
8. Carefully remove the Chain Guard Center from the Chain Guard
Cover, and and set it safely aside for reassembly.
54
R
1
2
1a
3