Schwinn IC2 Service Manual page 30

Disconnect the data cable from the console before you service this machine.
Note: Your machine may not match the image. For reference only.
Keep the flywheel stable during this procedure. Do not turn
the crank arms. Flywheel movement can pull fingers in and
cause injury.
1. Using a #2 Phillips screwdriver, loosen and remove the hardware
that attaches the Brake Cover to the Main Frame. Set the hardware
safely aside for reassembly.
NOTICE: Hold the Brake Cover so that it does not fall.
2. Carefully remove the Brake Cover and set it safely aside for
reassembly.
NOTICE: Do not crimp the cable.
3. Loosen the Resistance Knob (A) to the minimum resistance
setting.
4. Using a 3mm hex key, remove the hardware (B1) that attaches
the Brake Assembly (B) to the Frame Mount (C). Set the hardware
safely aside for reassembly.
Note: The nuts may turn along with the screws when you try to
loosen the hardware (B1). To hold the nut stable, wedge
a small flathead screwdriver diagonally between the nut
and the inside of the Frame Mount bracket (C).
5. Remove the old Brake Assembly (B) and set it safely aside.
If you are not replacing the Resistance Knob assembly— go to
step 11. Installation of the new Brake Assembly is the reverse
procedure.
30
A
B
C
B1