Part Replacement; Pedals - Schwinn Airdyne AD2 Service Manual

Replacing Parts
Disconnect the data cable from the console before cleaning, maintaining or repairing the machine.
For instructions to replace the following parts, please refer to the Assembly Manual for your bike:
• Seat
• Seat Post
• Front Stabilizer
• Rear Stabilizer
Replacing the Pedals
Disconnect the data cable from the console before you service this machine.
Note: Your machine may not match the image. For reference only.
Tools required: pedal wrench
1. Loosen and remove the old Pedals. Discard the old Pedals.
Note: The Left Pedal is reverse-threaded. Orientation is based
from a seated position on the bike. The Left Pedal has an
"L", the Right Pedal an "R".
2. Install the new Pedals. Carefully align the threads and hand
tighten to prevent crossthreading. Then tighten fully with pedal
wrench.
Note: The Left Pedal is reverse-threaded. Be sure to attach
Pedals on the correct side of the Bike. Orientation is
based from a seated position on the bike. The Left Pedal
has an "L", the Right Pedal an "R".
3. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled
and inspected for correct performance in accordance
with the Owner's Manual.
L
L
9
R
R