Schwinn Airdyne AD2 Service Manual page 14

3. Be sure the Data Cable is disconnected from the Console.
Remove the Console and set it safely aside.
NOTICE: Do not crimp the cable.
4. Using a #2 Phillips Screwdriver, remove the hardware that
attaches the Vent Cover and remove it. Set the hardware safely
aside for reassembly.
Note: The hardware that attaches the bottom of the Vent
Cover is removed during Shroud removal.
5. Installation is the reverse procedure.
6. Final Inspection
Inspect your machine to ensure that all hardware is tight and compo-
nents are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
14