Crank Covers And Connector Arms - Schwinn Airdyne AD2 Service Manual

Hide thumbs Also See for Airdyne AD2:

Table of Contents

Replacing the Crank Covers and Connector Arms

Disconnect the data cable from the console before you service this machine.

Note: Your machine may not match the image. For reference only.

Tools required: #2 Phillips screwdriver, 13mm socket and

wrench (or nutdriver), Spindle Removal Plate tool (plate, 2 hex

head bolts and press-in spacer), 10mm socket and wrench

Remove the Pedals. Refer to the "Replacing the Pedals"

procedure in this manual.

Carefully remove the Shrouds. Refer to the "Replacing

the Shrouds" procedure in this manual. Set the hardware

safely aside for reassembly.

Loosen and remove the Hardware (A1, A2) that attaches

the Crank Arm (A) to the Crank Cover (B). Remove the Crank

Arm and the Star Washers (B1) from the Crank Cover. Set the

hardware safely aside for reassembly.

Remove the Crank Cover (B).

Loosen and remove the hardware that attaches the Connector

Arm (C) to the Arm Pivot (D). Set the hardware safely aside for

reassembly.

To prevent possible serious injury, hold the Handlebar (E)

so that it does not fall. Tilt it forward and set the free end

of the Handlebar on the floor.

Or remove the Handlebar and Footpeg (F). Refer to the

"Replacing the Handlebars and Footpegs" procedure in

this manual. Set the hardware safely aside for reassembly.

4 mm

Table of Contents

Show Quick Links

Table of Contents