Schwinn Airdyne AD2 Service Manual page 30

9. Using eye protection, remove the C-Clip (G) from the Pulley
Shaft Assembly (F).
10. Using eye protection and a rubber mallet (or wooden block
and hammer), gently strike the Pulley Shaft Assembly (F) until it
works out of the Frame and releases the Crank Bearings (H).
Note: One Crank Bearing will be left in the Frame after the
axle is removed.
11. Installation is the reverse procedure.
NOTICE: Before you replace the Covers and Shrouds, check
the belt tension and adjust if necessary.
12. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
F
H
30
H
G
F
H