Table of Contents
Advertisement
- Put the tomograph on the plate and press it down so that each transducer is in a hole;
- Press the button "data collection" is located on the handles of the tomograph;
- If the tomograph is ready, the following information will be displayed on the screen (Figure18).
- If the tomograph is not ready, the following information will be displayed on the screen (Figure19).
In this case it is necessary to contact with service center of the manufacturer by e-mail at info@acs-international.com
or by phone: +49 681-9659-2270.
System options. When setting the device options, the following information is displayed on the screen, see Figure 20.
Figure 19
А1040 MIRA Low-Frequency Ultrasonic Tomograph
Figure 20
27
ACOUSTIC
CONTROL
SYSTEMS
1
Operation Manual
Advertisement
Table of Contents
