Adding A Button For Sequence Execution On Step Error - ABB COM600 series User Configuration Manual
Substation management units 5.1 sequence control
Hide thumbs
Also See for COM600 series:
- Data historian operator's manual (140 pages) ,
- User manual (104 pages) ,
- Configuration manual (66 pages)
Table of Contents
Advertisement
5.5.
54
COM600 series 5.1
Sequence Control Configuration Manual
Figure 5.4-6 Object properties for a a sequence manual mode acknowledgement 2-State
Indicator/Button
Adding a button for sequence execution on step error
Add a 2-State Indicator/Button for the purposes of sequence execution on step error
setting.
To add a button for executing a sequence on step error:
1. Drag and drop the 2-State Indicator/Button control from the Generic section in
the Symbols dialog to the SLD layout page.
2. Right-click the 2-State Indicator/Button and select Configure 2-State Indic-
ator/Button to launch the 2-State Indicator/Button Configuration dialog.
3. Configure the Indication properties as shown in Figure 5.3-3.
1MRS755001
execute_manual_object_properties.png
Advertisement
Table of Contents
