Sequence Control Configuration; Overview Of Configuration - ABB COM600 series User Configuration Manual

Substation management units 5.1 sequence control

Hide thumbs Also See for COM600 series:

Table of Contents

1MRS755001

3.1.

COM600 series 5.1

Sequence Control Configuration Manual

Sequence Control configuration

This section describes the steps involved in configuring a sequence. The same procedure

can be repeated to configure multiple sequences.

Before configuring a sequence, the communication information to multiple IEDs must

be configured. For more information on configuring the communication structure for

COM600, see COM600 User's Manual.

Sequence control views allow you to run configured sequences on COM600. Configuring

sequence control involves the following steps:

•

defining a sequence logical device and associated logical nodes for the logic processor

IED

•

defining a sequence (SFC program) in the logic processor

•

cross-referencing sequence data objects and breaker data objects to corresponding

sequence object and switch object members in the logic processor

•

defining a sequence SLD for using sequence control through COM600 WebHMI

configuration.

Figure 3.1-1 shows an example of a communication structure in the SAB600 tool

including four IEDs that communicate with COM600 using IEC 61850 protocol.

Table of Contents