Adding An Execution Mode Control - ABB COM600 series User Configuration Manual

5.4.
48
COM600 series 5.1
Sequence Control Configuration Manual
Figure 5.3-5 Object properties for the 2-State button
7. Repeat the steps 2 - 6 to add more 2-State Indicator/Button objects to the sequence
SLD functionality.

Adding an execution mode control

A new 2-State Indicator/Button is needed to change the mode of execution (auto-
matic/manual) for the sequence.
To add an execution mode control:
1. Drag and drop the 2-State Indicator/Button control from the Generic section in
the Symbols dialog to the SLD layout page.
2. Right-click the 2-State Indicator/Button and select Configure 2-State Indic-
ator/Button to launch the 2-State Indicator/Button Configuration dialog.
3. Configure the Indication properties as shown in Figure 5.3-3.
1MRS755001
2_state_object_properties.png