1MRS755001
5.6.
COM600 series 5.1
Sequence Control Configuration Manual
Figure 5.5-3 Object properties for a sequence execution on step error 2-State Indicator/Button
Adding a button for viewing sequence status
Add Multiple State Button controls to view the status of the sequence execution. These
controls can show the status of the sequence as a whole and status of each step in the
sequence.
To add a button for viewing the status of the whole sequence:
1. Drag and drop the Multiple State Button control from the Generic section in the
Symbols dialog to the SLD layout page.
2. Right-click the Multiple State Button and select Configure Multiple State Button
to launch the configuration dialog.
3. Configure the Indication properties as shown in Figure 5.3-3. Click Add State to
add more states for the sequence (idle, running, failed, passed).
The status values showing the sequence status as a whole and the status of each step
in the sequence can be one of four possible states, see Table 5.6-1. Include all the
states in the button configuration showing sequence status.
on_step_error_properties.png
57