How To Connect The Program To The Drive Application; How To Control The Execution Of The Program - ABB ACS800 Application Manual

How to connect the program to the drive application

The output of the Adaptive Program needs to be connected to the drive application
program. For that purpose the user needs two parameters:
• a connection parameter and
• a source selection parameter (pointer).
The figure below shows the connection principle.
Example:
The Adaptive Program
output is stored in parameter
84.09. The diagram shows
how to use the value as
speed reference REF1 in
the ACS800 Standard
Application Program.

How to control the execution of the program

The Adaptive Program executes the function blocks in numerical order, all blocks on
the same time level. This cannot be changed by the user. The user can:
• select the operation mode of the program (stop, start, editing)
• adjust the execution time level of the program
• delete or add blocks.
ACT. SIGNAL/
parameter (pointer)
PARAMETER
TABLE
1.01
1.02
8409
• • •
84.09
• • •
99.99
Source selection
Select
EXT1REF
11.10
Connection
parameter
Select
AI1
AI2
Speed
...
Reference
PTR
11.03
Adaptive Program
11