Configuring The Rootdn For An Ldap Server - Cisco Nexus 9000 Series Configuration Manual

Configuring the RootDN for an LDAP Server

Command or Action
switch(config)# show ldap-server
Step 4 (Optional) copy running-config startup-config
Example:
switch(config)# copy running-config startup-config
Related Topics
Configuring the RootDN for an LDAP Server
You can configure the root designated name (DN) for the LDAP server database. The rootDN is used to bind
to the LDAP server to verify its state.
Before you begin
Enable LDAP.
Obtain the IPv4 or IPv6 addresses or the hostnames for the remote LDAP servers.
SUMMARY STEPS
1. configure terminal
2. [no] ldap-server host {ipv4-address | ipv6-address | hostname} rootDN root-name [password password
[port tcp-port [timeout seconds] | timeout seconds]]
3. (Optional) show ldap-server
4. (Optional) copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2 [no] ldap-server host {ipv4-address | ipv6-address |
hostname} rootDN root-name [password password [port
tcp-port [timeout seconds] | timeout seconds]]
Cisco Nexus 9000 Series NX-OS Security Configuration Guide, Release 9.x
112
LDAP Server Configuration
Enabling or Disabling LDAP, on page 110
Configuring LDAP Server Groups, on page 113
Configuring the RootDN for an LDAP
Configuring LDAP Server Groups, on page 113
Configuring Periodic LDAP Server
Monitoring LDAP Servers, on page 122
Clearing LDAP Server Statistics, on page 123
Purpose
Copies the running configuration to the startup
configuration.
Process, on page 109
Server, on page 112
Monitoring, on page 119
Purpose
Enters global configuration mode.
Specifies the rootDN for the LDAP server database and the
bind password for the root.
Configuring LDAP