Cisco Nexus 9000 Series Configuration Manual page 71

Configuring RADIUS
2. radius-server host {ipv4-address | ipv6-address | hostname}
3. (Optional) show radius {pending | pending-diff}
4. (Optional) radius commit
5. exit
6. (Optional) show radius-server
7. (Optional) copy running-config startup-config
DETAILED STEPS
Command or Action
Step 1 configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2 radius-server host {ipv4-address | ipv6-address |
hostname}
Example:
switch(config)# radius-server host 10.10.1.1
Step 3 (Optional) show radius {pending | pending-diff}
Example:
switch(config)# show radius pending
Step 4
(Optional) radius commit
Example:
switch(config)# radius commit
Step 5 exit
Example:
switch(config)# exit
switch#
Step 6 (Optional) show radius-server
Example:
switch# show radius-server
Step 7
(Optional) copy running-config startup-config
Example:
switch# copy running-config startup-config
Related Topics
Configuring a Key for a Specific RADIUS
Cisco Nexus 9000 Series NX-OS Security Configuration Guide, Release 9.x
Purpose
Enters global configuration mode.
Specifies the IPv4 or IPv6 address or hostname for a
RADIUS server to use for authentication.
Displays the RADIUS configuration pending for
distribution.
Applies the RADIUS configuration changes in the
temporary database to the running configuration.
Exits configuration mode.
Displays the RADIUS server configuration.
Copies the running configuration to the startup
configuration.
Server, on page 47
Configuring RADIUS Server Hosts
45