Configuring The Copp Scale Factor Per Line Card - Cisco Nexus 9000 Series Configuration Manual

Configuring the CoPP Scale Factor Per Line Card

DETAILED STEPS
Command or Action
Step 1 configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2
control-plane
Example:
switch(config)# control-plane
switch(config-cp)#
Step 3 [no] service-policy input policy-map-name
Example:
switch(config-cp)# service-policy input PolicyMapA
Step 4 exit
Example:
switch(config-cp)# exit
switch(config)#
Step 5 (Optional) show running-config copp [all]
Example:
switch(config)# show running-config copp
Step 6 (Optional) copy running-config startup-config
Example:
switch(config)# copy running-config startup-config
Related Topics
Configuring the CoPP Scale Factor Per Line Card
You can configure the CoPP scale factor per line card.
The scale factor configuration is used to scale the policer rate of the applied CoPP policy for a particular line
card. The accepted value is from 0.10 to 2.00. You can increase or reduce the policer rate for a particular line
card without changing the current CoPP policy. The changes are effective immediately, so you do not need
to reapply the CoPP policy.
SUMMARY STEPS
1. configure terminal
2. control-plane
3. scale-factor value module multiple-module-range
Cisco Nexus 9000 Series NX-OS Security Configuration Guide, Release 9.x
478
Configuring a Control Plane Policy
Purpose
Enters global configuration mode.
Enters control plane configuration mode.
Specifies a policy map for the input traffic. Repeat this step
if you have more than one policy map.
You cannot disable CoPP. If you enter the no form of this
command, packets are rate limited at 50 packets per seconds.
Exits control plane configuration mode.
Displays the CoPP configuration.
Copies the running configuration to the startup
configuration.
Map, on page 475
Configuring Control Plane Policing