Radius And Server Group Configuration Scenario - D-Link DWS-1008 User Manual

DWS-1008 User's Manual
DWS-1008# clear server group shorebirds
success: change accepted.
The members of the group remain configured, although no server groups are shown:
DWS-1008# show aaa
Default Values
authport=1812 acctport=1813 timeout=5 acct-timeout=5
retrans=3 deadtime=0 key=(null) author-pass=(null)
Radius Servers
Server
-------------------------------------------------------------------------------------------
sandpiper
heron
coot
egret
Server groups
RADIUS and Server Group Configuration Scenario
The following example illustrates how to declare four RADIUS servers to an switch and
configure them into two load-balancing server groups, swampbirds and shorebirds:
1. Configure RADIUS servers. Type the following commands:
DWS-1008# set radius server pelican address 192.168.253.11 key elm
DWS-1008# set radius server seagull address 192.168.243.12 key fir
DWS-1008# set radius server egret address 192.168.243.15 key pine
DWS-1008# set radius server sandpiper address 192.168.253.17 key oak
2. Place two of the RADIUS servers into a server group called swampbirds. Type the following
command:
DWS-1008# set server group swampbirds members pelican seagull
3. Enable load balancing for swampbirds. Type the following command:
DWS-1008# set server group swampbirds load-balance enable
4. Place the other RADIUS servers in a server group called shorebirds. Type the following
command:
DWS-1008# set server group shorebirds members egret pelican sandpiper
5. Enable load balancing for shorebirds. Type the following command:
DWS-1008# set server group shorebirds load-balance enable
6. Display the configuration. Type the following command:
D-Link Systems, Inc.
Addr Ports
192.168.253.3 1812 1813
192.168.253.1 1812 1813
192.168.253.4 1812 1813
192.168.253.2 1812 1813
Configuring Communication with RADIUS
T/o Tries Dead State
5 3 0 UP
5 3 0 UP
5 3 0 UP
5 3 0 UP
326