D-Link DWS-1008 User Manual page 177

DWS-1008 User's Manual
0333001287
0333001285
Displaying Connection Information for Distributed APs
A Distributed AP can have only one active data connection. To display the system IP address
of the switch that has the active connection, use the following command:
show dap connection [dap-num | serial-id serial-ID]
The serial-id parameter displays the active connection for a Distributed AP even if that AP is
not configured on this switch. However, if you use the command with the dap-num parameter
or without a parameter, connection information is displayed only for Distributed APs that are
configured on this switch.
Displaying Service Profile Information
To display service profile information, use the following command:
show service-profile {
Entering show service-profile ? displays a list of the service profiles configured on the
switch.
To display information for service profile wpa_clients, type the following command:
DWS-1008# show service-profile wpa_clients
ssid-name:
beacon:
WEP Key 1 value:
WEP Key 3 value:
WEP Unicast Index:
Shared Key Auth:
WPA enabled:
ciphers: cipher-tkip
authentication: 802.1X
TKIP countermeasures time: 60000ms
Displaying Radio Profile Information
To display radio profile information, use the following command:
show radio-profile {name | ?}
D-Link Systems, Inc.
DWL-8220AP 10.3.8.54
DWL-8220AP 10.3.8.57
| }
?
name
D-Link ssid-type:
yes auth-fallthru:
<none> WEP Key 2 value:
<none> WEP Key 4 value:
1 WEP Multicast Index:
NO
Configuring DWL-8220AP Access Points
3 default
5 vlan-eng
crypto
web-portal
<none>
<none>
1
172