D-Link DWS-1008 User Manual page 158

DWS-1008 User's Manual
802.1X
Port groups
IGMP snooping
Maximum user
sessions
Caution: When you set the port type for AP use, you must specify the PoE state (enable or
disable) of the port. Use the switch's PoE to power D-Link DWL-8220APs only. If you enable
PoE on a port connected to another device, physical damage to the device can result.
To set the port type for AP access ports, use the following command:
set port type ap port-list
model {DWL-8220AP} poe {enable | disable} [radiotype {11a | 11b| 11g}]
You must specify the AP model and the PoE state.
You can specify one of the following for the radio type:
• 11a - 802.11a
• 11b - 802.11b
• 11g - 802.11g
The DWL-8220AP has two radios. One radio is always 802.11a. The other radio is 802.11b/g,
but can be configured for 802.11b or 802.11g exclusively. If the country of operation specified
by the set system countrycode command does not allow 802.11g, the default is 802.11b.
The DWL-8220AP has an internal 802.1b/g antenna as well as a connector for an external
antenna, so use of an external antenna is optional. It also has a connector for an optional
external 802.11a antenna. To specify the antenna model, use the set {ap | dap} radio
antennatype command.
AP radios configured for 802.11g also allow associations from 802.11b clients by default.
To set ports 1 through 4 and port 6 for the DWL-8220AP and enable PoE on the ports, type
the following command:
DWS-1008# set port type ap 1-4,6 model dwl-8220ap poe enable
This may affect the power applied on the configured ports. Would you like to continue? (y/
n) [n]y
Configuring an Indirectly Connected AP
If a DWL-8220AP access point that you want to manage using the switch is indirectly
connected to the switch through a Layer 2 or Layer 3 network, configure the AP using the
following command:
set dap dap-num serial-id serial-ID model {DWL-8220AP} [radiotype {11a | 11b| 11g}]
D-Link Systems, Inc.
Port uses authentication parameters
configured for users.
Not applicable
Enabled as users are authenticated and join
VLANs.
Not applicable
Configuring DWL-8220AP Access Points
153