D-Link DWS-1008 User Manual page 159

DWS-1008 User's Manual
The dap-num parameter identifies the Distributed AP connection for the AP. The range of
valid connection ID numbers is from 1-30.
For the serial-id parameter, specify the serial ID of the AP. The serial ID is listed on the AP
case. To display the serial ID using the CLI, use the show version details command.
The model and radiotype parameters have the same options as they do with the set port
type ap command. Because the switch does not supply power to an indirectly connected AP,
the set dap command does not use the poe parameter.
To configure Distributed AP connection 1 for the DWL-8220AP with serial-ID 0322199999,
type the following command:
DWS-1008# set dap 1 serial-id 0322199999 model dwl-8220ap
success: change accepted.
Clearing a DWL-8220AP from the Configuration
Caution: When you clear an access point, MSS ends user sessions that are using the AP.
To clear the port settings from a port, use the following command:
clear port type port-list
This command resets the port as a network port and removes all AP-related parameters from
the port.
Note: The clear port type command does not place the cleared port in any VLAN, not even
in the default VLAN (VLAN 1). To use the cleared port in a VLAN, you must add the port to
the VLAN.
To clear a Distributed AP, use the following command:
clear dap dap-num
Changing AP Names
The default name of a directly attached AP is based on the port number of the AP access port
attached to the AP. For example, the default name for a DWL-8220AP on AP access port 1
is AP01. The default name of a Distributed AP is based on the number you assign to it when
you configure the connection. For example, the default name for Distributed AP 1 is DAP01.
AP names appear in the output of some CLI show commands. To change the name of an AP,
use the following command:
set {ap port-list | dap dap-num} name name
D-Link Systems, Inc.
Configuring DWL-8220AP Access Points
154