D-Link DWS-1008 User Manual page 219

DWS-1008 User's Manual
The command applies only to the ports you specify. The port cost on other ports remains
unchanged.
To reset the cost of ports 3 and 4 in the default VLAN to the default value, type the following
command:
DWS-1008# clear spantree portcost 3-4
success: change accepted.
To reset the cost of ports 3 and 4 for VLAN beige, type the following command:
DWS-1008# clear spantree portvlancost 3-4 vlan beige
success: change accepted.
Changing the STP Port Priority
To change the priority of a port, use one of the following commands:
set spantree portpri port-list priority value
set spantree portvlanpri port-list priority value {all | vlan vlan-id}
The set spantree portpri command changes the priority for ports in the default VLAN
(VLAN 1) only. The set spantree portvlanpri command changes the priority for ports in a
specific other VLAN or in all VLANs.
Specify a priority from 0 (highest priority) through 255 (lowest priority). The default is 128.
The all option applies the change to all VLANs. Alternatively, specify an individual VLAN.
To set the priority of ports 3 and 4 in the default VLAN to 48, type the following command:
DWS-1008# set spantree portpri 3-4 priority 48
success: change accepted.
To set the priority of ports 3 and 4 to 48 in VLAN mauve, type the following command:
DWS-1008# set spantree portvlanpri 3-4 priority 48 vlan mauve
success: change accepted.
Resetting the STP Port Priority to the Default Value
To reset the STP port priority to the default value, use one of the following commands:
clear spantree portpri port-list
clear spantree portvlanpri port-list {all | vlan vlan-id}
The command applies only to the ports you specify. The port cost on other ports remains
unchanged.
D-Link Systems, Inc. D-Link Systems, Inc.
Configuring and Managing STP
214 214