D-Link DWS-1008 User Manual page 189

DWS-1008 User's Manual
Examples: To configure service profile wpa to use a raw PSK with PSK clients, type a
command such as the following:
DWS-1008# set service-profile wpa psk-raw c25d3fe4483e867d1df96eaacdf8b02451fa
0836162e758100f5f6b87965e59d
success: change accepted.
Disabling 802.1X Authentication for WPA
To disable 802.1X authentication for WPA clients, use the following command:
set service-profile name auth-dot1x {enable | disable}
Note: This command does not disable 802.1X authentication for non-WPA clients.
To disable WPA authentication in service profile wpa, type the following command:
DWS-1008# set service-profile wpa auth-dot1x disable
success: change accepted.
Displaying WPA Settings
To display the WPA settings in a service profile, use the following command:
show service-profile {name | ?}
To display the WPA settings in effect in service profile wpa, type the following command:
DWS-1008# show service-profile wpa
ssid-name:
beacon:
WEP Key 1 value:
WEP Key 3 value:
WEP Unicast Index:
Shared Key Auth:
WPA enabled:
ciphers: cipher-tkip, cipher-wep40
authentication: 802.1X
TKIP countermeasures time: 30000ms
The WPA settings appear at the bottom of the output.
Note: The WPA fields appear in the show service-profile output only when WPA is enabled.
D-Link Systems, Inc. D-Link Systems, Inc.
private
yes auth-fallthru:
<none> WEP Key 2 value:
<none> WEP Key 4 value:
1 WEP Multicast Index:
NO
ssid-type: crypto
none
<none>
<none>
1
Configuring User Encryption
184 184