General Wiring Guidelines - Danfoss VLT Safety Option MCB 150 Installation Manual

Hide thumbs Also See for VLT Safety Option MCB 150:
Table of Contents

Advertisement

Installation Guide | VLT® Safety Option MCB 150/151
1
1 2
3
2
Illustration 20:
Connecting Control Wiring
The connections are not pre-wired from factory.
9. Fit the LCP or blind cover in the extended LCP frame.
Connect power to the drive.
Set up the input/output functions in the corresponding parameters as mentioned in the chapter Safe Plug-in the VLT® Motion
Control Tool MCT 10 Operating Guide.
The commissioning test report is automatically generated via the Safe Plug-in in MCT 10 after downloading the parameters to the
safety option.
PROPER GROUNDING
Qualified personnel, in this case the operator or electrical installer, is responsible for proper grounding and compliance
with all applicable national and local safety regulations. Failure to have qualified personnel doing the wiring could result in
death or serious injury.
Only allow qualified personnel to do the wiring of the equipment.
-

4.1.5 General Wiring Guidelines

Inputs
Use appropriate wiring to exclude short circuits between the inputs or to a supply line.
Danfoss A/S © 2018.09
4
5
6
7
8
9
10
11 12
N O T I C E
W A R N I N G
Installation
AQ279747441421en-000101 / 130R0292 | 41

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vlt safety option mcb 151

Table of Contents