Danfoss VLT Safety Option MCB 150 Installation Manual page 71

Installation Guide | VLT® Safety Option MCB 150/151
Table 15: LCP Copy Messages
Message
0 RPM None
1(1)
Password
0-69 Password Protection
of safety Parameter
[1] Enabled
([0] Disabled)
0 RPM None
1(1)
Copy/Save 0-5 *
0-50 LCP Copy
[ ] 9
Safety Par. from LCP
0 RPM None
1(1)
Safety Par. from LCP
Copying...
00%
0 RPM None
1(1)
Safety Password
Please enter the safety
Password
0 0000000
0 RPM None
1(1)
Pa
0-
Password accepted
[0
([1] Enabled)
0 RPM None
1(1)
Pa
0-
Password rejected
[0
([1] Enabled)
Danfoss A/S © 2018.09
Description
The password protection of the safety parameters is enabled.
Copying the safety parameters from the LCP into the drive is selected.
The safety parameters get copied from the LCP into the drive.
If password protection is enabled in parameter 0-69 Password Protection of Safety Parameters, en-
ter the correct LCP-copy/parameter mismatch password (parameter 0-68 Safety Parameters Pass-
word).
If the entered password is correct, this overlay message is shown for some seconds.
If the entered password is wrong, this overlay message is shown for some seconds. Then the pass-
word can be entered again.
Service and Repair
AQ279747441421en-000101 / 130R0292 | 71