Danfoss VLT Safety Option MCB 150 Installation Manual page 72

Installation Guide | VLT® Safety Option MCB 150/151
Message
0 RPM 0.00A
!1(1)
SO Data Confirmation
Are you sure that you want
to overwrite the safety
parameters including the
level 1 password?
0 RPM 0.00A
!1(1)
SO Data Confirmation
Press [OK] to confirm
(commissioning test must be
performed) or [CANCEL] to
abort
Status
!1(1)
0 RPM None 0.00KW
SO Custom. completed
SO RESET required!
!Safe Stop [W68]
Off Remote SO Req.RESET
Status
!1(1)
0 RPM None 0.00KW
SO Custom. aborted
SO RESET required!
!Safe Stop [W68]
Off Remote SO Req.RESET
Table 16: Mismatch Between Safety Parameters in the Safety Option and in the Drive
Message
0 RPM 0.00 A
!1(1)
SO Param. Selection
Mismatch of SO param.set
detected. Please choose:
SO : Test1234_ 1.00
VLT : SafeSet1_ 1.00
Status
!1(1)
0 RPM None 0.00KW
SO Custom. completed
SO RESET required!
!Safe Stop [W68]
Off Remote SO Req.RESET
72 | Danfoss A/S © 2018.09
Description
Decision box for continuing overwriting the existing data or to abort the procedure.
Press [OK] to complete the customization of the safety option. A reset is required to finalize this
procedure.
Press [Cancel] to abort the customization of the safety option. A reset is required to finalize this
procedure.
Description
Whenever there is mismatch of safety parameters within the safety option and the drive, this se-
lection form is shown on the LCP. Select between the 'safety data on safe option' or the 'safety
data on frequency converter' as valid data.
If selecting [SO:...], the customization of the safety option is completed and a reset is required to
finalize this procedure.
Service and Repair
AQ279747441421en-000101 / 130R0292