Please read these instructions before installing or using this appliance for the first time. These instructions must be followed for the safe installation of the radiator. Any
problem, fault or damage caused by the non-observance of these instructions will not be covered under the manufacturer's warranty. This manual should be retained with
Page 1
PH Plus SMART PANEL CONVECTOR HEATER PH-075 Plus PH-125 Plus PH-150 Plus PH-200 Plus Please read these instructions before installing or using this appliance for the first time. These instructions must be followed for the safe installation of the radiator. Any problem, fault or damage caused by the non-observance of these instructions will not be covered under the manufacturer’s warranty.
Page 2
1.- WARNING Please read these instructions before installing or using this appliance for the first time. • The warranty of the heater will not cover any damage caused by non-observance of any of these instructions. • The instructions should be retained for future reference. This guide must be kept and given to any new owner.
2.- INSTALLATION INSTRUCTIONS - Open the package and check that it is the correct model and it is in good condition. - To obtain optimum performances it is necessary to maintain a minimum clearance of 50 cm between the panel heater and any inflammable material as furniture, curtains etc.
Page 4
3.- USING THE PANEL HEATER DIGITAL CONTROL WITH DAILY AND WEEKLY PROGRAMMING Digital DISPLAY: It shows the time, temperature and other messages. Heating indicator: This small dot will be lit when the heater is consuming energy. SUN indicator Frost protection key: If the display shows the time the heater is in frost protection mode.
Page 5
SWITCHING ON THE PANEL HEATER Once the heater is connected to a main supply, switch on the heater by setting the switch marked I-O positioned at the rigth side of the panel heater to “I”. The off position is marked “O”. SETTING THE TIME Press the key more than two seconds.
Page 6
Press the key to go to the next interval. The display will show 00:30 intermittently and, again, press one of the three keys to allocate SUN, MOON or OFF (frost protection) from 00:30h to 01:00h or press key directly if the existing temperature level is ok.
Page 7
WEEKLY PROGRAMMES It is possible to allocate different programs to different days of the week. To do this, the controller has to be upgrade from 24hr mode (factory default) to 24hr/7days mode as follows: Switch off the panel heater by turning off the main switch at the right side of the heater, the display will be Off. Press the P-SE key and at the same time turn on the main switch maintaining the key at least five seconds.
4.- ADVANCED FUNCTION OPEN WINDOW DETECTION With open window detection activated, the heating element will be disconnected automatically when a sharp decrease in temperature in the room is detected avoiding energy wastage. After this period of time, the panel heater returns to the prior operation mode.
7.- TROUBLESHOOTING The panel heater radiator does not heat. Check the heater or the air inlets are not covered. If the display shows the time, press the key to switch on the heater. Check that the DAY or NIGHT temperatures are right. The room does not reach the required Check the selected temperature is in accordance with the desired temperature.
11.- PRODUCT FICHE MODEL(S): GABARRON PH-075 Plus, PH-125 Plus, PH-150 Plus, PH-200 Plus Value Item Symbol Unit PH-075 PH-125 PH-150 PH-200 Plus Plus Plus Plus Heat Output Nominal heat output 1250 1500 2000 Minimum heat output N.A. N.A. N.A. N.A.
Page 12
The symbol on the product or in its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.