3. - USING THE THERMAL RADIATOR
Daily Programming:
Temperature level for each
time interval (1h) of the day.
Temperature setpoint.
Operating mode.
OK / Mode Button
Press the button to select
operation mode: Auto, Manual,
Off, and to set the value of the
different parameters.
GREEN BACKLIGHT
Pressing any button the display will illuminate with a soft green colour. After certain time if no buttons are pressed the display
backlight will turn off.
OPERATING MODES
The heater has three different operation modes that may be selected by pressing the OK/Mode button, these are: Auto,
Manual override and OFF.
AUTO
3.1. ON/OFF
Once the heater is connected to a main supply you can turn the heater ON by switching the main ON/OFF switch positioned at
the rear right side of the heater as shown above.
Main switch.
All models are
equipped with one
switch on the back
surface allowing the
heater disconnection.
G-Control Hub
connection indicator.
Heating on indicator.
Current set point
temperature in AUTO
mode.
Config / Prog Button
Press the button to programme
and configure the thermal radiator
in AUTO Mode.
MANUAL override
13
OFF
EN