Hose Installation - SRAM HydroR Service Manual

10 Remove the four reservoir cover bolts.
11
Use a rag to remove the reservoir cover and bladder assembly. Discard
the fluid into an oil pan.
12 Remove the banjo bolt and discard the hose.
H o s e I n s t a l l a t i o n
1 Spray isopropyl alcohol on the reservoir, bladder, and reservoir cover
and clean them with a rag. Install the bladder onto the reservoir cover.
If the brake system has been contaminated with mineral oil or DOT 5
fluid, flush all of the parts with soapy water, rinse them with clean water,
then allow all the parts to dry prior to rebuilding. Install new seals, a
new bladder, and replace the hose.
NOTI CE
T10
4 mm
31

Hose Installation