SRAM HydroR Service Manual page 32

2 Apply grease to the new o-rings and install them onto both sides of the
new banjo.
3 Install the banjo and hose into the hood.
4 Align the bladder assembly in the reservoir cover with the reservoir in
the hood.
5 Install the four reservoir cover bolts at an alternating sequence until a
torque of 1.3-1.5 N·m (11-13 in-lb) is achieved.
6 Install the hatch cover onto the hood. Tighten the three hatch
DOT grease
DOT grease
4 mm 3.9-4.4 N·m (35-39 in-lb)
T10 1.3-1.5 N·m (11-13 in-lb)
Phillips #1 0.1 N·m (1 in-lb)
32
Hose Installation