SRAM HydroR Service Manual page 37

16 Install the hose firmly into the brake caliper while threading the
compression nut by hand. Tighten the compression nut.
17
Install the banjo boot over the compression nut.
Replacing the hose removes all of the fluid from the system. You must bleed the brakes before reinstalling the brake pads. Installing the brake pads
prior to bleeding the brakes could contaminate the brake pads and lead to a brake failure. For brake bleed and brake pad replacement instructions,
visit www.sram.com/service.
This publication includes trademarks and registered trademarks of the following companies:
TORX® is a registered trademark of Acument Intellectual Properties, LLC
10 mm
⚠ CAUTION
5-6 N·m (44-52 in-lb)
Hose Installation
8 mm
37