SRAM HydroR Service Manual page 13

5 Tighten the caliper body bolt.
6
Post mount only: Remove the banjo bolt o-ring. Apply grease to the
new o-ring and install it on the bolt. Install the bolt into the caliper.
Flat mount only: Remove the o-rings from the banjo bolt. Apply grease
to the new o-rings and install them on the banjo bolt so one is on each
side of the banjo fitting.
T25 9.8-11.8 N·m (86-104 in-lb)
DOT grease Post Mount
DOT grease Flat Mount
Post and Flat
Post Mount
Flat Mount
13
Caliper Piston Installation