SRAM HydroR Service Manual page 25

7 Use needle nose pliers or a flat blade screwdriver to install the circlip
onto the pivot pin with the rounded side facing outward.
Inspect the circlip to make sure it is installed properly. If the circlip is
missing or not installed properly, it could cause the pivot pin to fall out
of the brake.
8
Spray isopropyl alcohol on the brake and clean it with a rag.
9 Replace the shifter cable, if needed.
10 Install the hood cover.
NOTI CE
Flat blade screwdriver or pliers
Master Cylinder Piston Installation
Flat blade screwdriver or pliers
25