Master Cylinder Piston Removal - SRAM HydroR Service Manual

M a s t e r C y l i n d e r P i s t o n R e m o v a l
DOT fluid will damage painted surfaces. If any fluid comes in contact with a painted surface (e.g. your frame) or printing on the brakes, wipe it off
immediately and clean it with isopropyl alcohol or water. Damage to painted and/or printed surfaces by DOT fluid is not covered under warranty.
There are two stop plate types for HydroR disc brakes: stop plate
generation 1, and stop plate generation 2. Follow the procedure for the stop
plate type in your lever assembly.
1 Remove the shifter cable from the derailleur cable anchor points
according to the user manual on www.sram.com/service, if applicable.
Remove the handlebar tape. Loosen the handlebar clamp and remove
the brake lever from the bicycle.
2 Remove the hood cover.
3 Use a pick to remove the circlip from the lever pivot pin.
N OT ICE
Stop plate gen. 1
5 mm
Pick
Stop plate gen. 2
Pick Shift brake lever
Brake lever

Master Cylinder Piston Removal

17