SRAM HydroR Service Manual page 24

5 Shift-brake lever: Install the inner pivot barrel into the outer pivot
barrel in the lever so the holes in the pivot barrels align with the reach
adjust pushrod in the hood.
Brake lever: Install the inner pivot barrel into the lever so the hole in
the pivot barrel aligns with the reach adjust pushrod in the hood.
Thread the reach adjust pushrod into the pivot barrel
counter-clockwise.
6 Install the pivot pin into the inset hole on the hood and through the
lever blade hole so that the pin protrudes slightly.
Orient the lever bias spring with the long arm of the spring against the
brake lever.
Use needle nose pliers to hold the spring into place so you can push
the pivot pin through the lever bias spring and through the other hole
in the hood.
Shift-brake lever
2.5 mm Brake lever
Master Cylinder Piston Installation
2.5 mm Shift-brake lever
2.5 mm Brake lever
Needle nose pliers
24