Xantrex Xanbus System Control Panel Owner's Manual page 41

Fault Reference Table
Table 2 Fault Reference Table
Fault
number Message Type
F250 System clock Manual
not set. Set
correct time.
F251 A device is lost. Manual
Check
connection.
New device Manual
F252
detected. Check
device settings.
F500 Internal failure. Manual
Service
required.
F501 Memory failure. Manual
Service
required.
97-0022-01-01
Cause Action
On initial startup, Set the clock to the correct
the clock needs to be time. See "Using the Clock
set. The system will Menu" on page 21.
not operate correctly
until it is.
The SCP has lost Check network connection
communications between the SCP and the
with another device device.
on the network.
You have connected Acknowledge the message
a new device to the and check that the device
network or is properly configured.
reconnected a
disconnected device.
The silicon serial ID Reset the SCP by
number has failed removing and restoring
and the SCP has network power. If problem
gone into Standby persists, call customer
mode. service.
The SCP has Reset the SCP by
suffered a non- removing and restoring
volatile memory network power. If problem
failure. persists, call customer
service.
Table 2 Fault Reference Table
Fault
number Message Type
Internal reset. Manual
F503
Call customer
support.
F504 Lost network Automatic
connection.
Internal failure. Manual
F505
See guide.
Troubleshooting
Cause Action
The real-time clock Reset the SCP by
in the SCP has removing and restoring
failed. network power. If problem
persists, call customer
service.
The SCP has lost Check connection between
communications the SCP and the network.
with the network
because of a faulty
connection or
electronic signal
disruption.
A controller fault Reset the SCP by
has occurred and the removing and restoring
SCP has gone into network power. If problem
Standby mode. persists, disconnect and
reconnect network cables.
33