Xantrex Xanbus System Control Panel Owner's Manual page 40

Troubleshooting
Table 1 Warning Reference Table
Warning
number Message Type
W252 Please confirm: Manual
Restore default
settings.
The value failed to Manual
W254
change. Try again.
System clock not Manual
W255
set. Set correct
time.
W256 A device is lost. Manual
Check connection.
New device Manual
W257
detected.
Check device
settings.
W258 Device instance Manual
is duplicated.
32
Cause Action
Press Enter to restore
You have selected
the Restore Defaults default settings or
Func to cancel.
command.
The setting you are Put the system in
changing can only Standby mode, change
be changed when the setting, then return
the system is in the system to
Standby mode. Operating mode.
On initial startup, Set the clock to the
the clock needs to be correct time. See
set. The system will "Using the Clock
not operate correctly Menu" on page 21.
until it is.
The SCP has lost Check network
communications connection between
with another device the SCP and the
on the network. device.
You have connected Acknowledge the
a new device to the message and check
network or that the device is
reconnected a properly configured.
disconnected
device.
Two networked Select a different
devices of the same instance ID on one of
type have the same the devices' Setup
instance. menu.
Table 1 Warning Reference Table
Warning
number Message Type
W501 SCP has fixed a Manual
memory problem,
restored defaults.
Not reporting; Manual
W502
Info may be
missing.
Xanbus System Control Panel (SCP) Owner's Guide
Cause Action
The SCP Acknowledge the
encountered an warning and reset
internal memory configurable settings
problem upon if necessary.
startup. To remain
operational, the SCP
restored its default
settings.