After Every Steam Operation - Thermador Masterpiece MEDS301WS Use And Care Manual

NOTICE: The appliance may become damaged due to
the use of unsuitable liquids.
Do not use distilled water, highly chlorinated tap water
(>4 mg/l) or other liquids.
Only use cold, fresh tap water, softened water or non-
carbonated mineral water.
Do not overfill tank above max level line to avoid water
from spilling inside the tank housing.
Notes
If your water is very hard, we recommend that you use
▯
softened water.
If you only use softened water, you can set the water
▯
hardness range to "softened".
If you use mineral water, set the water hardness range
▯
to "4 very hard".
If you use mineral water, you must only use non-
▯
carbonated mineral water.
Open the appliance door.
1.
Pull out the water tank from the right side of the oven
2.
cavity (figure ).
!
Fill the water tank with cold water up to the "max."
3.
mark (figure )
"
Fully close the tank cover until it locks.
4.
Insert the filled water tank (figure
5.
Ensure that the water tank has been pushed in all the
6.
way. The water tank should be level with the tank
cavity (figure ).
$
Close the appliance door.
7.
).
#

After Every Steam Operation

WARNING
9
RISK OF SCALDING
Hot steam can escape when you open the
appliance door. Steam is not visible at certain
temperatures. Do not stand too close to the
appliance when opening it. Open the appliance
door with caution. Keep children away.
WARNING
9
RISK OF BURNS
The appliance grows hot during operation. Let
appliance cool down prior to cleaning.
NOTICE: ENAMEL DAMAGE: Do not start any
operations when there is water on the oven cavity floor.
Before the operation, wipe the water from the oven cavity
floor.
The remaining water is pumped back into the water tank
after every operation with steam. Then empty and dry the
water tank. Moisture remains in the oven cavity. To dry
the oven cavity, you can either use the "Drying
operating mode or dry the oven cavity by hand.
Notes
Once the appliance has been switched off, the display
▯
remains lit for a little longer to remind you to empty the
water tank.
Remove limescale marks with a cloth soaked in
▯
vinegar, then wipe with clean water and dry with a soft
cloth.
Empty Water Tank
NOTICE:
Do not dry the water tank in the hot oven cavity. This
▯
will damage the water tank.
Do not clean the water tank in the dishwasher. This will
▯
damage the water tank.
Open the appliance door.
1.
Remove the water tank.
2.
Empty the water tank, clean it with detergent and then
3.
rinse it thoroughly with clean water.
Dry all parts with a soft cloth.
4.
Rub the seal on the cover until dry.
5.
Leave to dry with the cover open.
6.
Close the cover on the water tank and push it down.
7.
Insert the water tank and close the appliance door.
8.
"
ª
27