Control Panel Edr 2000; Description Of Pushbuttons; Programme Selector - Electrolux EDR 2000 Service Manual

2.1 Control panel EDR 2000

2.1.1 Description of pushbuttons and LEDs
The control panel, together with the push buttons, features 10 or 13 LEDs, a programme selector and a display with 3
digits. The options can be selected only after setting a drying cycle with the selector.
The functions of the pushbuttons and the LEDs depend on the configuration code of the appliance.
Time select button
A delayed start time of from 1 – 12 hours can be set by pressing this button during the programme selection phase. The
time is shown on the display. The length of the delay is increased by repeatedly pressing the button. For the first two
hours, the length of the delay is increased in steps of half an hour each time the button is pressed. After the first two hours,
each press of the button increases the length of the delay by an hour.
Remaining moisture button
For fine adjustment of the remaining moisture content of the washing. Changing the setting from + to +++ makes the
washing progressively dryer. Press the RESTFEUCHTE button repeatedly until the lamp above the desired remaining
moisture level is lit. When the degree of moisture is changed, the time shown on the display also changes.
"START/PAUSE" pushbutton
Start
When a drying programme has been selected using the programme selector, the LEDs for the three phases (drying,
cooling and - if featured - anti-crease/end of cycle) light and the START/PAUSE LED flashes.
After selecting the desired option(s), press this bufton to start the cycle. The corresponding LED, as well as the
drying phase LED, remains lit.
Pause
lf START/PAUSE is pressed while a drying cycle is being performed, the dryer interrupts the cycle and the appliance
goes to PAUSE mode; the corresponding LED flashes. Certain options may be modified while the appliance is in
PAUSE mode.
Press START/PAUSE again to resume the cycle from the point at which it was interrupted.
"NO BUZZER" pushbutton
This option can be selected only when the dryer is in "selection" mode (set-up).
Press this button to deactivate the buzzer function. The LED lights to indicate this selection. To re- activate the
buzzer function, press the button again; the LED will switch off.
Even when the buzzer function is deactivated, the buzzer will continue to signal alarm conditions.
Anti-crinkle+ button
When this additional function is selected, the anti-crinkle phase after completion of the drying sequence is lengthened
by 60 minutes. The washing can be removed at any time during the anti-crinkle phase.
Wool and silk buttons
If the textiles are still too damp after the drying sequence with the Wool or Silk programmes, an additional drying
sequence with the Wool or Silk programme can be added by additionally setting the remaining moisture level +, ++,
or +++.
Important: do not overdry wool or silk!

2.2 Programme selector

The 16-position programme selector (with incorporated ON/OFF switch) is
built into the board.
The first nine positions are common to all versions (i.e. always select the
same programmes); programmes 10 to 14 vary according to the
configuration of the appliance.
06.2005 R.Kurzke 599 522 797 EN
- 5 -