Table of Contents
Advertisement
GB
4
INSTALLATION
The installation must be carried out by a professional.
WARNING
When welding in an environment with increased electrical danger, only power
sources intended for this environment may be used. These power sources are
marked with the symbol
4.1
Terminating resistor
The ends of the CAN bus must be fitted with terminating
resistors to avoid communication interference.
The terminating resistor is delivered with the power source.
One end of the CAN bus is at the control panel (U8
has an integral terminating resistor.
The other end is at the FeedControl and must be fitted with
the terminating resistor, as shown on the right.
If U8
is used together with W8
2
the W8
must be disconnected, see the instruction
2
manual for the W8
2.
4.2
Example of a robotic welding system
Note! A mounting kit and a cable kit are required for mounting to a robot, please
contact your local ESAB dealer for more information.
bm54d1ea
the terminal resistor in
2,
- 8 -
), which
2
© ESAB AB 2012
Advertisement
Table of Contents
