Table of Contents
Advertisement
4 INSTALLATION
4
INSTALLATION
The installation must be carried out by a professional.
CAUTION!
This product is intended for industrial use. In a domestic environment, this product may cause
radio interference. It is the user's responsibility to take adequate precautions.
CAUTION!
Remove any packaging material prior to use. Do not block the air vents at the front or rear of
the welding power source.
4.1
Location
Position the power source so that cooling air inlets and outlets are not obstructed.
A. Minimum 8 in. (200 mm)
B. Minimum 8 in. (200 mm)
4.2
Lifting instructions
The power source can be lifted using any of the handles.
0447 956 001
- 13 -
© ESAB AB 2023
Advertisement
Table of Contents
