Related Manuals for ESAB Aristo MechTig 3000i
Summary of Contents for ESAB Aristo MechTig 3000i
- Page 1 Aristo MechTig 3000i Instruction manual 0460 369 101 GB 20121105 Valid for serial no. 718-xxx-xxxx, 950-xxx-xxxx...
- Page 2 - 2 -...
-
Page 3: Table Of Contents
1 SAFETY ............2 INTRODUCTION . -
Page 4: Safety
SAFETY Users of ESAB equipment have the ultimate responsibility for ensuring that anyone who works on or near the equipment observes all the relevant safety precautions. Safety precautions must meet the requirements that apply to this type of equipment. The following recommendations should be observed in addition to the standard regulations that apply to the workplace. - Page 5 There may be potential difficulties in ensuring electromagnetic compatibility of class A equipment in those locations, due to conducted as well as radiated disturbances. - 5 - © ESAB AB 2007 dp04d1ea...
-
Page 6: Introduction
As the person responsible for the equipment, it is your responsibility to obtain information on approved collection stations. For further information contact the nearest ESAB dealer. ESAB can provide you with all necessary welding protection and accessories. INTRODUCTION MechTig 3000i is a welding power source intended for mechanized welding. -
Page 7: Installation
Lifting instruction Location Position the welding power source such that its cooling air inlets and outlets are not obstructed. - 7 - © ESAB AB 2007 dp04d1ea... -
Page 8: Mains Power Supply
Connecting the terminating resistor To avoid communication interference, the remote socket must be fitted with a terminating resistor, when a remote control unit is not connected. - 8 - © ESAB AB 2007 dp04d1ea... -
Page 9: Operation
OVERHEAT appears in the lower right-hand corner of the control panel. When the temperature drops, the overheat protection is automatically reset and the field stops flashing red. For further information see the control panel user manual. - 9 - © ESAB AB 2007 dp04d1ea... -
Page 10: Maintenance
Check that the cables are correctly connected. Check that the correct current value is set. Check that the correct electrodes are being used. Check the mains power supply fuses. Check that the correct welding gas is being used. - 10 - © ESAB AB 2007 dp04d1ea... -
Page 11: Ordering Spare Parts
Repair and electrical work should be performed by an authorised ESAB service technician. Use only ESAB original spare and wear parts. Spare parts may be ordered through your nearest ESAB dealer, see the last page of this publication. - 11 - ©... -
Page 12: Diagram
Diagram - 12 - © ESAB AB 2007 dp04e... - Page 13 - 13 - © ESAB AB 2007 dp04e...
-
Page 14: Ordering Number
0459 745 882 Welding power source Aristo MechTig 3000i â 0459 839 016 Spare parts list Aristo MechTig 3000i Instruction manuals and the spare parts list are available on the Internet at www.esab.com - 14 - © ESAB AB 2007 dp04o... -
Page 15: Accessories
8 m ......... . 0460 210 881 Return cable 4,5 m, 50 mm ....0156 743 907 - 15 - © ESAB AB 2007 dp04a... - Page 16 ESAB Romania Trading SRL ESAB VAMBERK s.r.o. SOUTH AFRICA ESAB Mexico S.A. Bucharest Vamberk ESAB Africa Welding & Cutting Ltd Monterrey Tel: +40 316 900 600 Tel: +420 2 819 40 885 Durbanvill 7570 - Cape Town Tel: +52 8 350 5959...