Tension Release Wire - Brother S-7300A Service Manual

6. ASSEMBLY

6-17-3. Tension release wire

Pass through the hole in the bed at F (inside hole).
5mm
Secure the wire at the position where the
threaded section
approximately 5 mm.
1. Tension release wire
2. Wire holder U
3. Screw
4. Cord holder
5. Screw
6. Nut
7. Wire holder D
8. Screw
103
(b) protrudes by
(1) Tension release wire
Install the end to the tension release plate (1).
18mm
Secure the wire at the position where the wire
sheath (a) protrudes by approximately 18 mm.
Assemble while referring to
"Adjusting the thread tension
mechanism".
S-7300A
1115D
1116D
1121D