Thread Trimmer Solenoid And Tension Release Wire; Thread Trimmer Solenoid Assembly - Brother S-7300A Service Manual

6. ASSEMBLY

6-17. Thread trimmer solenoid and tension release wire

6-17-1. Thread trimmer solenoid assembly

 Set so that there are no gaps at A, B and C when the
thread trimmer solenoid is at the "ON" position, and then
tighten 2 in the illustration below.
Solenoid stopper plate
1. Thread trimmer solenoid assembly
2. Screws [4 pcs]
3. Rubber cushion
4. Collar
5. Washer
6. Socket bolt (Provisionally tighten)
(Fully tighten after adjustment)
7. Screw (Loosen) (Fully tighten after adjustment)
101
 Set so that there are no gaps at D and E when the
thread trimmer solenoid is at the "OFF" position, and
then tighten 6 and 7 in the illustration below.
(Flush)
Solenoid lever
Touching
1110D
S-7300A
1111D
Insert into the
rubber cushion 3.
1112D