Adjusting The X-Over Seam Sensor (Premier Specifications) - Brother S-7300A Service Manual

7-13. Adjusting the X-over seam sensor (Premier specifications)

NOTE:
・ Make this adjustment after fully reassembling the sewing machine.
Check that the presser foot and needle plate are attached to the sewing machine.
・
(1)
(2)
(4)
[A]
1050D
1051D
<If there is a 4 mm spacer>
1049D
1. While pressing the menu key (1) and the home key (2),
press the power switch (3).
2. Select "X-over seam thickness Sens ADJ" (4).
3. Turn the machine pulley (5) to the angle where screen [A]
disappears.
4. Lower the presser foot (6), and then press the OK key
(7).
5. Insert the 4 mm spacer (9) in between the presser foot (6)
and the needle plate (8), and then press the OK key (7).
6. Turn off the power switch(3).
(7)
(7)
S-7300A
7. ADJUSTMENT
140