Table of Contents
Advertisement
Chapter 3: Setup and Installation
Figure 3-2. Blade Enclosure with Switch Modules Installed
8U 820C Enclosure
MBM-GEM-001 Switch Module
4U 414E Enclosure
MBM-XEM-001 Switch Module
5. Push the release handle to the closed position.
NOTE: After the module has been installed and the handle locked, it will turn on and a POST
test will run to verify it is working properly. If there are no problems the blue Init. OK LED on
the module will illuminate and you will see an OK under I
in the S
screen of
NITIATED
WITCH
the management software utility.
NOTE: If the module is installed in a top bay it must be positioned upside-down.
3-3
Hide quick links:
Advertisement
Table of Contents
