Jet Information - Mytee T-REX Technical Support

Jet Information

Jet part number
Jet size
Flow
Installing Optional 7
Optional 7 jet can be added on to the T-REX
th
To install, simply unscrew the hex screw in the center of the brass spray manifold and screw in the
jet.
B114A
7th Jet
Motor Carbon Brushes
The DC motors on the T-REX
will wear with time and usage. It is important that the brushes be replaced at the first signs of wear.
If the brushes wear out and let the commutator and armature come in contact, it can cause costly
damage to the speed control board used in the machine.
Signs of Brush Wear
• On-and-off cycling. If motor begins to cycle, as if turning on-and-off rapidly, the brushes are likely
worn.
• Shaking, banging, or slapping sound from motor.
• Sparks and/or smoke from motor.
• Marked decrease in power of motor.
In any of these cases, replace the brushes immediately.
Replacement Carbon Brushes
: Part # C311-BMK
• T-REX
™
Jr.: Part # C311B-BMK
• T-REX
™
T-REX T-REX
™
B183 B183
1/8K-1.0 1/8K-1.0
0.2 GPM 0.2 GPM
Jet on T-REX
th
Jet part number
Jet size
Flow
, and T-REX
™
Jr. Flexstar
™
B114A
11002
0.2 GPM
™
only.
™
Info
B114A
11002
0.2 GPM
Jr. models have carbon brushes. These carbon brushes
™
TS-TREX-09/02/15 • PAGE # 8