NTT docomo Arrows Me F-11D Instruction Manual page 62

❖
Scanning Wi-Fi network
･
Set Wi-Fi to ON in advance.
From the Home screen, m→[Settings]
1
→[Wi-Fi]→[SCAN]
❖
Adding Wi-Fi network
Enter network SSID or security to add Wi-Fi network
manually.
･
Set Wi-Fi to ON in advance.
From the Home screen, m→[Settings]
1
→[Wi-Fi]
2
[ADD NETWORK]
3
Enter a network SSID of Wi-Fi network to
add→Select security
･
Security can be set to [None], [WEP], [WPA/WPA2
PSK] or [802.1x EAP].
4
Enter additional security information as
required→[Save]
❖
Disconnecting Wi-Fi network
From the Home screen, m→[Settings]
1
→[Wi-Fi]
2
Select a connected Wi-Fi network→[Forget]
✔INFORMATION
･
When you disconnect Wi-Fi network turning Wi-Fi OFF,
connection is automatically made if available Wi-Fi
network exists when Wi-Fi is turned ON next time.
❖
Advanced Wi-Fi settings
From the Home screen, m→[Settings]
1
→[Wi-Fi]
m→[Advanced]
2
3
Set each item
Network notification : Set to notify you when Wi-Fi
open network is available.
Wi-Fi Auto ON/OFF : Set whether to automatically
turn Wi-Fi to ON or OFF if available Wi-Fi network is
detected in the area where you have connected to
Wi-Fi once.
Wi-Fi sleep policy : Set whether to use Wi-Fi when the
terminal screen is OFF or while the battery is
charged.
MAC address/IP address : Display MAC address, IP
address.
✔INFORMATION
･
[Wi-Fi Auto ON/OFF] does not work if Airplane mode or
Wi-Fi tethering is ON.
･
The terminal may not connect automatically even when
[Wi-Fi Auto ON/OFF] is activated because Wi-Fi
information in the area is changed etc. In such case,
connect manually.
60
Settings