NTT docomo Arrows Me F-11D Instruction Manual page 61

◆ Wi-Fi
With Wi-Fi function of the terminal, you can use mail or
access the Internet by connecting to the home or company
network or public wireless LAN access point.
To connect to a LAN access point, you need to set
connection information.
■ Reception interference caused by Bluetooth
Wireless LAN (IEEE802.11b/g/n) and Bluetooth function
use the same frequency band (2.4GHz). If you use the
wireless LAN function and Bluetooth function of the
terminal at the same time, reception interference may
occur and the communications speed may lower. Also,
you may hear noise or have a connection problem.
Even when you use only wireless LAN function of the
terminal, the same problem may occur when someone
uses a Bluetooth device near you. In these cases, do the
following.
･
Keep the terminal over 10 m away from a Bluetooth
device.
･
Within 10 m, turn off the Bluetooth device.
■ Available channels
1 - 13 channel frequency bands can be used in Japan, and
1 - 11 channel frequency bands overseas.
❖
Connecting to network with Wi-Fi ON
From the Home screen, m→[Settings]
1
2
Set [Wi-Fi] to [ON]
･
You can also set ON/OFF by the setting switch on
the Notification panel.
3
[Wi-Fi]→Select a Wi-Fi network
･
When you select a Wi-Fi network protected by
security, enter a password (security key) and tap
[Connect].
･
After selecting Wi-Fi network, connection selection
screen may appear.
✔INFORMATION
･
Even when Wi-Fi is ON, packet communication is
available. However, while you connect Wi-Fi network, Wi-
Fi comes first. When the Wi-Fi network is disconnected, it
switches to 3G network and GSM/GPRS network
connection automatically. Note that packet
communication fee applies for using the network.
･
If you enter a wrong password (security key) when
selecting an access point to connect, [Avoided poor
Internet connection] appears. Make sure the password
(security key). If [Avoided poor Internet connection]
appears in spite of entering correct password (security
key), correct IP address may not have been obtained.
Check signal condition and reconnect.
･
To use the following docomo services and functions via
Wi-Fi, Wi-Fi option password is required beforehand. To
make settings, from the Home screen, m→[Settings]
→[docomo service]→In [Wi-Fi], tap [Wi-Fi option
password].
- spモードメール (sp-mode mail), Personal area, docomo
Application manager, ドコモバックアップ (docomo
backup) application, ｉチャネル (i-channel), ｉコンシェ
ル (i-concier)
59
Settings