Charging - NTT docomo Arrows Me F-11D Instruction Manual

Charging

❖
Precautions on charging
･
If you use the terminal while charging, it may take time
to complete charging or charging may not complete.
･
It is normal for the terminal or AC adapter to become
warm while charging. When the terminal becomes
warm, charging may stop temporarily for the safety.
When the terminal becomes extremely hot, stop using
immediately.
･
Charging failed in the followings. In case of charging
error, a message may appear or the indicator LED may
blink. Remove the terminal from the charger or remove
the battery pack.
- Charging voltage is high
- The battery pack is over-charged/over-discharged
- Charging is not complete after 5 hours or more
- Battery temperature exceeds guaranteed operating
range
･
iC transmission is not available during charging.
･
When charging starts with the battery empty, the
terminal may not be immediately activated after turning
the power ON. In this case, charge the terminal while
keeping it turned OFF, and turn it on after a while.
❖
Charging times (approximate)
The following is the time for charging an empty battery
pack with F-11D's power switched OFF. Charging with the
terminal ON or under low temperature requires longer
time.
AC adapter Approx. 180 min.
DC adapter Approx. 180 min.
❖
Operation time on full charge
(approximate)
The following time varies by the charging method and
operating environment.→P140
Continuous FOMA/
stand-by 3G
time
GSM
Continuous FOMA/
call time 3G
GSM
❖
Battery pack life
･
The battery pack is a consumable part. Each time it is
charged, time available with each charging reduces.
Talking on the phone for a long time while charging may
reduce the battery pack lifetime.
･
When a time available with each charging is reduced to
about a half from that of a new battery, replacement of
the battery is recommended because it is near the end of
life. The battery pack may swell out as it comes to near
the end of its lifetime depending on the usage
conditions, but it is not a problem.
27
Stationary (Auto) : Approx. 440 H
Stationary (Auto) : Approx. 280 H
Approx. 260 min.
Approx. 380 min.
Before using the terminal