NTT docomo Arrows Me F-11D Instruction Manual page 139

◆ When updating software
･
Do not remove the battery pack while updating
software. The update may fail.
･
Software update should be done with battery fully
charged. You are recommended to connect charging
cable when updating software.
･
Software cannot be updated in the following cases.
- During a call
- When 圏外 (out of service area) is displayed
- During international roaming
- When Airplane mode is on
- While upgrading the operating system
- When date and time are not set correctly
- When the remaining battery is not sufficient for
software update
- When the remaining memory is not sufficient for
software update
* During international roaming or when the terminal is out of
service area, updating software is not available even though
you are connected via Wi-Fi.
･
Software update (downloading or rewriting) may take
time.
･
Making/Receiving calls, communications functions and
other functions are disabled during software update.
Only incoming calls can be answered while
downloading.
･
Stay in a place with strong radio wave condition when
updating software. Software update may be canceled if
the radio wave condition is not good enough.
･
If software update is not needed, [No update is needed.]
appears.
･
During international roaming or when the terminal is out
of service area, [When docomo network is not available,
or during roaming software update is not available even
if Wi-Fi is connected.] or [When docomo network is not
available, or during roaming, install cannot be started
even if Wi-Fi is connected.] appears. The same
messages appear even while connecting via Wi-Fi.
･
SMS sent during software update is stored in the SMS
center.
*
*
*
･
When updating software, your private information
concerning F-11D (model, serial number, etc.) is
automatically sent to the server for software update
managed by DOCOMO. DOCOMO does not use the sent
information for purposes except software update.
･
When software update has failed, the terminal may not
activate or [Update failed] appears and all operations
may become unavailable. In that case, please bring the
terminal to DOCOMO-specified repair office.
･
When PIN code is set, the PIN code entry screen appears
during resetting after rewriting and you need to enter
PIN code.
･
While updating software, do not activate other
applications.
◆ Updating software automatically
Update file is automatically downloaded and software is
updated at the specified time.
❖
Automatic update setting
･
The settings of Software Update is set to [Automatic
Update] by default.
From the Home screen, m→[Settings]
1
→[About phone]→[Software Update]→
[Configure the software update]
2
[Automatic Update]/[Manual Update]
137
Appendix/Index